When a PC is connected to a switch port, firstly the port issues an 802.1x authentication challenge to the attached device (the 802.1x supplicant). The supplicant replies with username and password and then an authentication request is passed to a configured Radius server.
The error message can look similar to this:
%DOT1X_SWITCH-5-ERR_ADDING_ADDRESS: Unable to add address [mac address] on Fa0/10
This means that the supplicant MAC address cannot be added. This can happen when the TCAM is full or the address exists as a secure address on another port.
The message can come from the port-security subsystem. In some cases, these messages are generated by switches that run Cisco IOS Software Release 12.2(25)SEE2.
If this message appears only once, then this can be ignored.
In order to resolve this issue, if the hardware is full, remove some Dynamic addresses with the clear mac address-table command, which are automatically added to the address table and dropped from it when they are not in use.
If the supplicant address is secured on another port, manually remove it from that port with the clear port-security command.
I am trying to figure out an issue with Small packets (sub-200Byte) which caused firewall performance issue and so far I can only pin point to the 4507 LAN switch doing the fragmentation...Standard MTU1500 is in use though. From "show ip traffi...
Two tunnel is configured on a router the source and destination of the tunnel is on one destinationAnd we have one vrf That one of these tunnels inside to vrfAnd dynamic routing configure On two tunnelsBut one of tunnel down then when configure mode ipip ...
Hello everyone, I'm practicing in a 2960 with Packet Tracer. I wanted to test virtual lines access with ssh version 2.I tried setting from 2 to 10 with #line vty 2 10 and it doesn't work. I'm asked about password, but I never log in, even w...
This issue just started. I am no longer able to log into my switch via a web browser. Credentials are correct. It worked fine last month. Tried using different browsers. Keeps telling me invalid username or password. I'm using the same o...
Muy buenos dias.En este caso molesto por algo que deberia ser sencillo, pero no funciona.Tengo un Router con 2 interfaces ETH conectadas y configuradas en redes distintas, y una ruta estatica por default.El tema es que de a red B no puedo llegar a la red ...