Buenas tardes
Tengo la siguiente configuracion de mi ISP:
IP: 187.218.98.81
MS: 255.255.255.252
GW: 187.218.98.81
Vlan: 109
En este modem, solo se puede acceder mediante el puerto lan 1 configurando la vlan.
Tengo un router Cisco C891F al cual quiero configurar el puerto de Wan para que reciba el internet del modem, y luego con nat , distribuir el internet en mi red interna. He configurado las interfaces y el nat pero no consigo hacer que se pueda acceder al internet desde los clientes. Esta es mi configuracion actual:
Current configuration : 2173 bytes
!
! Last configuration change at 17:33:07 UTC Sat Feb 1 2020 by cisco
version 15.3
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
!
!
!
!
!
!
!
!
!
!
!
!
!
interface BRI0
no ip address
encapsulation hdlc
shutdown
isdn termination multidrop
!
interface FastEthernet0
ip address 10.20.240.254 255.255.255.0
ip nat inside
ip virtual-reassembly in
duplex auto
speed auto
!
interface GigabitEthernet0
no ip address
!
interface GigabitEthernet1
no ip address
!
interface GigabitEthernet2
no ip address
!
interface GigabitEthernet3
no ip address
!
interface GigabitEthernet4
no ip address
!
interface GigabitEthernet5
no ip address
!
interface GigabitEthernet6
no ip address
!
interface GigabitEthernet7
no ip address
!
interface GigabitEthernet8
no ip address
ip nat outside
ip virtual-reassembly in
duplex auto
speed auto
!
interface GigabitEthernet8.109
encapsulation dot1Q 109
ip address 187.218.98.81 255.255.255.252
ip nat outside
ip virtual-reassembly in
!
interface Vlan1
no ip address
!
interface Async3
no ip address
encapsulation slip
!
ip forward-protocol nd
ip http server
no ip http secure-server
!
!
ip nat inside source list 100 interface GigabitEthernet8.113 overload
ip route 0.0.0.0 0.0.0.0 187.218.98.82
!
!
access-list 100 permit ip 10.20.240.0 0.0.0.255 any
!
control-plane
!
!
!
mgcp behavior rsip-range tgcp-only
mgcp behavior comedia-role none
mgcp behavior comedia-check-media-src disable
mgcp behavior comedia-sdp-force disable
!
mgcp profile default
!
!
!
!
!
line con 0
login local
no modem enable
line aux 0
line 3
modem InOut
speed 115200
flowcontrol hardware
line vty 0 4
login local
transport input all
line vty 5 15
login local
transport input all
!
scheduler allocate 20000 1000
!
end
de antemano gracias por la ayuda
