Join us live on Wednesday, May 15 at 10 am PT as we deep-dive into the
newly introduced Catalyst 9100 Access Point and Catalyst 9600 Switch.
This is the gear that will deliver the promise of WiFi 6! Post your
Join us live tomorrow December 18th at 9 am PT as we explore features of
the new Catalyst 9200 switch and the Catalyst 9800 Wireless Controller
with Greg Doria and Munider Sambi. Join the conversation - post your
Join us November 15 at 10 am PT as we talk to Cisco’s senior Enterprise
Networks executives about our recent announcements around SD-WAN and the
Catalyst expansion. As always, our Cisco experts are ready to answer
your questions, so post them below.
Hi......everyone ...my question is related to vlan......i have an cisco switch 2960G and i have configured vlans e.g vlan 100 for wirednetworks and vlan 200 foe wireless network......now i want that both vlans users are communicate with my med...
Okay, I'm a newbie. My question: I have set up 2 routers, connected to each other: R1int s0/3/0ip address 192.168.1.1 255.255.255.252int lo0ip address 18.104.22.168 255.255.255.0 R2int s0/3/0ip address 192.168.1.2 255.255.255.252int lo0ip address 1.1....
Hello Everyone, I have 3 SG350 and connected each other Here is the configSpoiler (Highlight to read)SW1#sh runconfig-file-headerSW1v22.214.171.124 / RLINUX_923_093CLI v1.0file SSD indicator encrypted@ssd-control-startssd configssd file passphrase con...
I have BGP learned prefixes that I want to redistribute into EIGRP but with different metrics. I use a route-map with a "set metric +512000" (with or without the + sign) but that does not take effect... I still receive the same metric with the default red...
Greetings!,Hope you guys doing good.In my organization, I have following NAT rule configured.nat (TRPS-Inside,any) source static NET10 NET10 destination static NET10 NET10 no-proxy-arp route-lookupI am not able to understand its significance as I am still...