“Use Serviceability Features to Troubleshoot your Cat9K as a Cisco TAC Engineer”
This event took place on Tuesday 1st, December 2020 at 10hrs PDT
This event provides an introduction to the main Cat9K serviceability features. Serviceability is the provision of the necessary tools and features to service a Cisco product and to allow the end-user to monitor, identify faults, troubleshoot, and restore service.
You will learn how these tools and features work and apply your knowledge on the platform. The main goal is to efficiently troubleshoot a live network (even in degraded conditions) and to identify the root cause or trigger of a problem without the need to reproduce the “broken” state.
Our focus will be on Polaris IOS-XE 17.3.1 and earlier serviceability features for the Catalyst 9x00 series.
Packet Tracer (SPF – Show Platform Forward and PSV – Packet State Vector)
Aaron Cespedes is a Technical Consulting Engineer on the Enterprise Routing & Switching team at the Customer Experience (CX) Center in Mexico. He has worked with different Cisco Catalyst Switching Platforms, including backbone technologies, for 7+ years, and specializes in Switching technologies. Aaron holds a Bachelor’s degree in Telecommunications from the Universidad Politecnica of Costa Rica. He holds a CCNP in R&S certifications. He currently pursues a CCIE in R&S.
For more information, visit the networking category.
Do you know you can get answers before opening a TAC case by visiting the Cisco Community.
I want to add my SW Catalyst Express 500 Series In my network park I found two problems:
1-It's impossible to have telnet to configure with putty
2-How to activate trunk mode on a port with the web assistant to see communicate with other Cisco switches
Hi all; Suppose I receive routes with "10.149.42.0/24" prefix from adjacent router and I want to match exactly the "10.149.42.254" IP address, for filtering purpose. How can I match exactly this IP address using a prefix list? Thanks
Hi,We're trying to set dual Internet connections on a branch site and each vEdge has one ISP connection.And, vEdges are having the other ISP link through TLOC Extension.Each vEdge has default GRE routes undet VPN1 for DAI Internet traffic. (ip gre-route 0...
Hi everyone. I purchased a WS-X6708-10GE module with DFC3CXL daughter card for my Cisco 7606 router. there are two SUP720-3B supervisor on this router. After installation and reboot, it shows the status "other" for this module. What is the problem?&n...
Hi, My company is having a routing or load-sharing problem so I hope you can help me. The following diagram is the current situation: I don't know when the direct layer 2 connection between SW1 and SW2 went down, the link is a 20km fiber connect...