cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
587
Views
20
Helpful
18
Replies
Cisco Employee

Re: ESC: Correct Info not retrieved using ETSI REST APIs

Or you can integrate NSO NFVO with ESC using NETCONF/YANG, which is available today.

Re: ESC: Correct Info not retrieved using ETSI REST APIs

Is it possible to use ESC with SOL 003 and when ESC interacts with NSO-NFVO over NETCONF and responds back to OSS over SOL 03 interface?

I.e OSS ->SOL003 API<-> ESC <-NETCONF->NSO+NFVO

 

If this is possible. Pls guide me to change config in ESC for this.

 

As of now If I am sending ETSI SOL 3 messages to ESC, ESC is using SOL 005 messages by default to interact with NSO.

 

Thanks

Satish

Cisco Employee

Re: ESC: Correct Info not retrieved using ETSI REST APIs

Using both ETSI API and NETCONF API on the same ESC instance is not supported, you are meant to use one or the other. The reason is that different subsystems within ESC can get out of sync if both were used.

 

ESC does not use SOL005, only SOL003.

 

OSS does not interact with VNFM in the ETSI MANO architecture.

 

As KJ suggested, best option at this time is to use the NSO-ESC NETCONF integration.

 

Re: ESC: Correct Info not retrieved using ETSI REST APIs

Sorry by bad,  Pls read NFVO in place of OSS.

And that for clarifications. Let me see. How i can make use of it till ETSI support is in place for both.