It would be appreciated if someone explained the NSO behavior described below to me. I am deploying a service instance which enables interface SVI on Cisco Neuxs, which causes the device to enable 'Vlan 1' SVI - this one is, however, not explicitly c...
view more
I downloaded and installed the nso-5.3 installer for Linux. I followed the instructions up to source /opt/ncs/ncs-5.3/ncsrc. So far so good. I created the directory/opt/ncs/ncs-5.3/ncs-runThe next step isncs-setup --dest /opt/n...
view more
Hi, I have been trying to use Navu under /scheduler:scheduler/scheduler:task to iterate on the names as part of a helper function that sets an action-param based on the current date-time. None of that really matters except for the part where t...
view more
Hi all,
We have a requirement for DB backup and restore.
Exploring the forum I found 2 options
1) ncs-backup: This is applicable only for system-install. We are using local-install.
2) ncs_load: This take the config backup in cli/xml format....
view more
