06-30-2009 11:24 AM
hi all
Network node maybe has 4-degree, so i used the WXC board, but i confuse of whether it support 80 channel by using interleaver?
Solved! Go to Solution.
07-01-2009 04:42 AM
You need a deinterleaver also to separate those 100GHZ and then feed to your WXC board (It is like a Demux for those 2 40 channel signal into odd & even).
Check the following link for part code of interleaver/deinterleaver
To extend it to 80 channel you will need lot of other cards you can take help from cisco or Cisco Transposrt Planner to build a BoM(Bill of Material)
06-30-2009 07:12 PM
Yes you need interleaver if you want to plan for 80 channels, as Max channel support by one card is 40 so you need to mux again 2 40 channel card.
06-30-2009 10:21 PM
Thx u very much.
But you know the 40-WXC board can only support 100GHz, that means only 40 channel (not support odd and even), so maybe WXC not support 80 channels at all, right?
07-01-2009 04:42 AM
You need a deinterleaver also to separate those 100GHZ and then feed to your WXC board (It is like a Demux for those 2 40 channel signal into odd & even).
Check the following link for part code of interleaver/deinterleaver
To extend it to 80 channel you will need lot of other cards you can take help from cisco or Cisco Transposrt Planner to build a BoM(Bill of Material)
07-01-2009 09:44 AM
hi,viyuan700
But you know, Demux for 80 channels is devide into odd and even two types, and then use the interleaver can support 80 channels, but WXC only has even type according to the manuals. So can you give more detail, or WXC can not support 80 channels?
07-01-2009 11:47 AM
As i said in other post DWDM system are not flexible they come with a rider and in my opinion here rider is that if you want to increase to 80 channel, then you cannot use WXC (as it is for odd channels ONLY not even ) but you can use WSS for Even channels.
In your inital post you mentioned Degree 4 Mesh Patch panel, so you have to plan in advance. You can use these odd wavelngth on which WXC work , where you have Multiring or Mesh kind of network and for others you can use WSS for even channel. After Deinterleaver Odd can be given to WXC and Even to WSS.
07-02-2009 11:35 AM
Thank you very much, i am clear now.
06-30-2009 10:21 PM
Thx u very much.
But you know the 40-WXC board can only support 100GHz, that means only 40 channel (not support odd and even), so maybe WXC not support 80 channels at all, right?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide