Hi All,
I am trying to setup OTV between two routers.
Using show otv adjacency I can see the other router with stat UP, But the VLAN I want to extend has NFC as its current state.
# show otv vlan
OTV Extended VLANs and Edge Device State Information (* - AED)
Legend:
(NA) - Non AED, (VD) - Vlan Disabled, (OD) - Overlay Down
(DH) - Delete Holddown, (HW) - HW: State Down
(NFC) - Not Forward Capable
VLAN Auth. Edge Device Vlan State Overlay
---- ----------------------------------- ---------------------- -------
1200 inactive(NFC) Overlay1
I cannot find any documentation on this state and what it can be caused by.
Does someone know what can cause this state? What can I do to troubleshoot this?
This is my current config:
feature otv
otv site-vlan 1508
interface Overlay1
otv join-interface port-channel2
otv control-group 239.1.1.1
otv data-group 232.1.1.0/28
otv extend-vlan 1200
no shutdown
otv site-identifier 0x1508
Any help would be appreciated :)
