Hi
I hava a problem about UCS Blade re-acknowledging.
I had the problem blade to decommission, and replace the same model blade.
But when I insert the Blade, but it still show Needs Resoulation
And I Click e-acknowledge , it show "failure reacknowledge Slot x. Cause child mgmtcontroller [sys/chassis-x/blade-x/mgmt|mgmt](0xa794e08a)
of computrBlade [sys/chassis-x/blade-x] is already attached [sys/chassis-x/blade-x/mgmt|mgmt|0xa794e08a]..
If anyone had encountered the same problem ?
Thanks a lot.