cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2824
Views
0
Helpful
1
Replies

Why configuring clock using clock set command is not accepted in nexus 7k?

dorsia
Beginner
Beginner

Hello,

I have a message like this:

Admin-CORE1_VDC# clock set 15:26:00 7 december 2014
Setting clock from CLI is not allowed in this VDC.

Use the following config command to use the "clock set" command.
clock protocol none vdc <vdc_id>

 

If I issue that command the message shows like this:

Admin-CORE1_VDC# clock protocol none vdc 2
                   ^
% Invalid command at '^' marker.
Admin-CORE1_VDC# conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Admin-CORE1_VDC(config)# clock protocol none vdc 2
                           ^
% Invalid command at '^' marker.
Admin-CORE1_VDC(config)# 

Pleas advice:

Thanks,

Dani

 

1 Reply 1

ashfaq82
Beginner
Beginner

You need to select the protocol as none if you are not using NTP or PTP in your environment. This will allow you to manually configure the time on you device.

NX-1(config)# clock protocol none

NX-1(config)# clock set 09:14:00 04 May 2021


Tue May 4 09:14:00 EST 2021

Time source is Hardware Calendar

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers