1750 routers and SNA

[a.burchell]

I have 2 cisco 1750 connected by a 1MB linc using static routes. This is all working fine.

I now need to set up SNA so remote AS400 screens will work. Can anybody tell me hos to set this up please as I have never used SNA before. Is their a specific IOS version I need ??

[Harold Ritter]

Can you tell us more about the application(s) you use to access the remote AS400. If your AS400 supports TN5250 or TN3270, you wouldn't need to support SNA traffic, as these two applications run over IP.

Hope this helps,

[a.burchell]

I am not sure about those 2 protocols that you have mentioned but I will find out. Thanks

[jolmo]

You will need an IOS with IBM feature set (DLSw, etc).

This is a link for a very basic DLSw configuration between 2 routers (Ethernet-to-Ethernet), but there are a lot of config examples at Cisco website:

http://www.cisco.com/en/US/tech/tk331/tk336/technologies_configuration_example09186a0080093ece.shtml

HTH

[a.burchell]

Thanks, you have pointed me in the right direction.