01-08-2003 09:46 PM - edited 03-02-2019 04:02 AM
Can I configure the Ethernet interface of a 2500 series router with subinterfaces to route between VLANs of an attached switch (cluster)?
Thanks in advance
01-08-2003 10:53 PM
No.
1: Subinterfaces & Intervlan routing are only possible on Fast Ethernet ports.
2: The 2500 series is old technology. It does not "know about" VLANs.
01-09-2003 05:57 AM
Old Technology?? Do you know how many 2500 series routers are deployed arounfd the world?? A 2514 with 2 ethernet port can route between VLANs.
01-09-2003 06:38 AM
I need to be able to do Inter-VLAN routing connecting to one Ethernet Interface on a router. I was not sure if in fact 2500's were capable. Apparently they are not.
I appreciate your answer nonetheless.
Kevin
01-09-2003 06:41 AM
Thanks for your response. I was under the impression that they were not...
What about 2600 series? Are they VLAN aware/capable?..
thanks again
01-09-2003 06:43 AM
The 2600 series in modular allowing different hw configuartions With a fastethernet interface installed you can use sub interfaces
01-09-2003 07:04 AM
2500 can't do subinterface routing on the ethernet interface but 2600 can do even on the normal ethernet interface starting from 12.2.1 software.
But if you are thinking about doing vlan routing , it is better to have the fastethernet interface because of the amount of traffic
hope this helps
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide