3620 with NM-2FE2W

[lcanario]

Hi all,

I have to specify an router to handle traffic of 04 fastethernet port with 802.1Q encapsulation in LAN side and 05 serial interface (2M) in WAN side.

I'm thinking about using 3620 router with two NM-2FE2W. But, I don't know if the router has enough processor and memory capacity for using the two modules.

Do you have any information about it ?

How can I get information about processor capacity on Cisco web ?

Thanks.

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.