3725 and Multilink Frame Relay

[b.calsing]

I have a 3725 and have 2 - VWIC-2MFT-T1's. Trying to configure MFR. When I go to setup the mfr interface (int mfr1) I get a invalid input detected. The commad is there when I type int ?. Running IOS 12.2(15)T14. Any help would greatly be appreciated.

[Georg Pauwen · Accepted solution]

Hello,

which feature pack do you have ? Certain feature packs like e.g. IP Base require 12.3 for Multilink Frame Relay...

Regards,

GP

[b.calsing]

Thank you very much. I was running ip,ipx,appletalk; made the change to ip,ipx,appletalk plus and there ya go.