I have 2 3750x switches in a stack. Both running version c3750e-universalk9-mz.152-1.E1. If I use the command sh hw-module I can see all 4 ports of the modules. (2 on switch 1 and 2 on switch 2). I can't get a link light on the module on switch 1. If I move the cables down to the ports on switch 2 they link up correctly. Is there something I can do to test the module itself to determine if the module is bad? All 4 ports are setup the same. Trunk ports connected to 2 UCS servers. Any help would be greatly appreciated.
Thanks.
