4006 chassis & 4232-l3 module upgrade

[jaehoon.heo]

Hello.

We have 4006 switch with engine2 & 4232-l3.

I'll replace engine2 with engine V.

Question : Could I used 4232-l3 interface port(32port fastethernet) with engine V.

Thank you.

[pkhatri]

Hi,

The Supervisor Engine V does not support the WS-X4232-L3, as per:

http://www.cisco.com/en/US/products/hw/switches/ps4324/prod_module_installation_guide09186a00801fad91.html

Hope that helps - pls rate the post if it does.

Paresh

[jaehoon.heo]

so much thank you.

one more question : how about engine iv(4515) ?.

I think same that... but i can't find document about 4515 and 4232-l3.

[jaehoon.heo]

I find document about 4232-l3 and engine

There is no support, however, for the router module when you use it in conjunction with Supervisor Engine 2+, 3, 4, or 5

http://www.cisco.com/en/US/customer/products/hw/switches/ps663/products_tech_note09186a0080094959.shtml

thank you.