AS5300 failed authentication

[jwise]

Hi,

I am using an AS5300 for authentication for a small ISP. I have two T1's for connection and 48 modems. When I try to do a multilink ppp connection with ISDN my authentication fails, but if I change it to use only a single line the authentication works just fine. Any thoughts on why this happens?

Thanks

[a-vazquez]

We’ll need to look at debug ppp negotiation and debug ppp authentication to see what’s happening during the event. I would get those together and call TAC.

[jwise]

Here is the debug for it:

23:16:32.626: ISDN Se0:23: RX <-  SETUP pd = 8  callref = 0x01C1

23:16:32.626:         Bearer Capability i = 0x8890

23:16:32.626:         Channel ID i = 0xA98393

23:16:32.626:         Calling Party Number i = '!', 0x81, '2625229082'

23:16:32.626:         Called Party Number i = 0x80, '1011'

23:16:32.634: %LINK-3-UPDOWN: Interface Serial0:18, changed state to up

23:16:32.638: ISDN Se0:23: TX ->  CALL_PROC pd = 8  callref = 0x81C1

23:16:32.638:         Channel ID i = 0xA98393

23:16:32.638: ISDN Se0:23: TX ->  CONNECT pd = 8  callref = 0x81C1

23:16:32.638:         Channel ID i = 0xA98393

23:16:32.666: ISDN Se0:23: RX <-  CONNECT_ACK pd = 8  callref = 0x01C1

23:16:34.442: %ISDN-6-DISCONNECT: Interface Serial0:18  disconnected from

9082 ventisdn, call lasted 1 seconds

23:16:34.442: ISDN Se0:23: TX ->  DISCONNECT pd = 8  callref = 0x81C1

23:16:34.442:         Cause i = 0x8090 - Normal call clearing

23:16:34.486: ISDN Se0:23: RX <-  RELEASE pd = 8  callref = 0x01C1

23:16:34.494: %LINK-3-UPDOWN: Interface Serial0:18, changed state to down

23:16:34.498: ISDN Se0:23: TX ->  RELEASE_COMP pd = 8  callref = 0x81C1