backup link on two parallel networks

[amarkumar]

Hi,

I am having intra web server connected to two parallel network, one is on ethernet and other is on token ring. Both the network is connected to other four offices. The network connected to ethernet card is having T1 connection with other four offices and network on token ring is 56K dialup.

Now I have to make 56k dialup network as a backup network for T1 network.

Please guide me.

Lots of thanks in advance

Amar

[ruwhite]

What routing protocol? You're easiest bet is to use the backup interface command, if you can, but otherwise it's going to be to set up a floating static route to point through the dial link as an alternative.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/dial_c/dcdbakdp.htm

Might be what you are looking for...

Russ

[amarkumar]

thanks a lot for the reply. When I join this project there was no routing protocols configured. They have configured static route.

Can I configured Routing and remote access on server and then configure floating route ???

Please help.

Amar