BVI1 BW 10000

[bleucube]

First time working with Bridging. Was wondering why is my Virtual Interface only showing a BW of 10000 Kbit and all of the other interfaces are set to 100000 Kbit?

Just trying to troubleshoot a slow down and came across that. Is it auto? How can I set it? Should it be 10000 Kbit?

BVI1 is up, line protocol is up

Hardware is BVI, address is 0008.a34e.d907 (bia 0000.0000.0000)

Internet address is 172.22.1.1/24

MTU 1500 bytes, BW 10000 Kbit, DLY 5000 usec, rely 255/255, load 1/255

Encapsulation ARPA, loopback not set

ARP type: ARPA, ARP Timeout 04:00:00

Queueing strategy: fifo

Output queue 0/0, 0 drops; input queue 0/75, 0 drops

Thanks much!

[vmiller]

Well, since its virtual, my suspicion is that the speed was hard coded in the

IOS waaay back when. My guess is its something that routing protocols use/need

(I'm thinking EIGRP) for metric calculation. given the load numbers, i's doubt that this is the slowdown point