Cannot access CISCO ROUTER 7200
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-06-2002 02:26 AM - edited 03-01-2019 08:22 PM
Hi,
I had to reset the router, after i executed the step 7 of this
document
(Password Recovery Procedure for the Cisco 7200 Series Routers)
http://www.cisco.com/warp/public/474/pswdrec_7200.shtml
I am unable to access the router, now when I access it (through
console) I only see the following letters
ÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇÇ
Could someone help me in this problem ? How can I access the router
again ?
Regards,
Joao
- Labels:
-
Other Networking
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-06-2002 12:32 PM
Just a thought. Its possible that something went wrong when setting the configuration register, and the baud rate was accidentally changed. Just experiment with the baud rate settings in your terminal program. Change the setting and try to reconnect. Hit enter a couple of times and if the screen still show jibberish, disconnect and try it again. Wash, rinse, repeat...
Good luck! Hope it helps.
Hope it helps.
