CEF per-packet load-share on 6500 / sup720

[m.blake]

I have a client who has 1 6500 in each of 2 locations. They have 2 x OC3 connections between the 6500's. Is it possible to run per-packet load-share on these two interfaces to utilize these links equally? How do you turn off L3 switching to enable this? What is the recommended configuration for this scenario?

[#2]

Per-packet load-sharing is not supported on PFC due to the nature of hardware-based CEF forwarding on Cat6k. Please refer to the link for Load Balancing on 6500 Series :

http://www.cisco.com/warp/public/cc/pd/si/casi/ca6000/tech/c65sp_wp.htm

As mentioned in the following document, "ip load-sharing per-packet" will only apply to traffic being forwarded by MSFC in software level:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_7_6/confg_gd/cef.htm#1096770