02-07-2013 04:37 AM - edited 03-03-2019 06:57 AM
I've been trying to set up my new Cisco 1921 Router to provide internet access to my local network but with no success. I've been reading guides and looking at videos and I have to be missing something becaouse I can't access internet (ping/tracert) from my local network.
The DHCP server works fine and the clients on my local network gets ip-adresses from the router but can't ping or tracert outside the local network.
"sh ip interface brief" - shows the following:
Interface IP-Address OK? Method Status Protocol
GigabitEthernet0/0 85.*.*.* YES DHCP up up
GigabitEthernet0/1 10.0.0.1 YES manual up up
NVI0 85.*.*.* YES unset up up
The GigabitEthernet0/0 gets its ip-address from my ISP.
"sh ip nat translations" - is showing nothing.
Here is my config:
Current configuration : 3040 bytes
!
! Last configuration change at 12:44:10 UTC Thu Feb 7 2013
! NVRAM config last updated at 12:03:22 UTC Thu Feb 7 2013
!
version 15.0
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname router
!
boot-start-marker
boot-end-marker
!
enable secret 5 ***
enable password ***
!
no aaa new-model
!
no ipv6 cef
ip source-route
ip cef
!
!
ip dhcp excluded-address 10.0.0.1 10.0.0.99
!
interface GigabitEthernet0/0
ip address dhcp
ip nat outside
ip virtual-reassembly
no ip route-cache
duplex auto
speed auto
!
interface GigabitEthernet0/1
ip address 10.0.0.1 255.255.255.0
ip nat inside
ip virtual-reassembly
no ip route-cache
duplex auto
speed auto
no mop enabled
!
ip forward-protocol nd
!
ip http server
ip http authentication local
ip http secure-server
!
ip nat inside source list 1 interface GigabitEthernet0/0 overload
!
access-list 1 permit 10.0.0.0
Solved! Go to Solution.
02-07-2013 04:44 AM
Hi,
no access-list 1
access-list 1 permit 10.0.0.0 0.0.0.255
Regards.
Alain
Don't forget to rate helpful posts.
02-07-2013 04:44 AM
Hi,
no access-list 1
access-list 1 permit 10.0.0.0 0.0.0.255
Regards.
Alain
Don't forget to rate helpful posts.
02-07-2013 04:54 AM
Thank you, I've totaly missed that part! most gratefull!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide