01-14-2004 04:15 AM - edited 03-02-2019 12:52 PM
Hi,
We had an image in router 2600 which we thought of upgrading. As there is memory constraint, we deleted the image. But still the router was showing image deleted and the memory is not freed. We tryed squeeze command but it didn't work. Finally we rebooted the router and landed in rommon mode. Here in rommon mode, it is accepting only some of the commands and that too after typing the same for around 15 to 20 times. We are not able to copy the new image from tftp as the command is not accepted. Hard rebooting the router also did not work. Plz someone help.
Thanks,
Sarath
01-14-2004 08:08 AM
Try Xmodem Procedure to upload your image...
Good luck
01-14-2004 08:28 AM
tftpdnld is a better option for a 2600 in rommon , you must have a locally attached PC with the image on it
http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008015bf9e.shtml
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide