cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
299
Views
0
Helpful
1
Replies

cisco 678 port forwarding problem

colbyd1
Level 1
Level 1

I have a cisco 678 and when I open a port set nat entry add 10.0.0.2 xxxx tcp, my connections (whether gaming or p2p) fail after a few minutes. I have a static ip. I have updated al nic drivers and all firewalls are disabled.

any suggestions?

1 Reply 1

vkapoor5
Level 5
Level 5

See if you are using the correct syntax as in http://www.cisco.com/univercd/cc/td/doc/product/dsl_prod/c600s/600inop/rconfig.htm .

You could probably check if the NAT translation entry is still available. Static entries should never timeout and should remain in the table