02-09-2024 06:09 PM
Hey Cisconians!
I kindly ask for some help with a config on a Cisco ASR1001 router. I have a 10G fiber link from this router that is connected in our cage and the interface shows UP/UP at the moment. I cannot adjust speed and duplex or Encaps 802.1Q on the interface.
Here are the Cisco Interfaces. Te0/0/0 is the fiber port connected to the patch panel to the Megaport X-Connect.
AWS-DC-RTR#sh ip int b
Interface IP-Address OK? Method Status Protocol
Te0/0/0 unassigned YES unset up up
Te0/0/1 192.168.51.249 YES manual up up
GigabitEthernet0/0/0 unassigned YES unset down down
GigabitEthernet0/0/1 unassigned YES unset administratively down down
GigabitEthernet0/0/2 unassigned YES unset administratively down down
GigabitEthernet0/0/3 unassigned YES unset administratively down down
GigabitEthernet0/0/4 unassigned YES unset administratively down down
GigabitEthernet0/0/5 unassigned YES unset administratively down down
GigabitEthernet0 unassigned YES DHCP down down
AWS-DC-RTR#sh interfaces tenGigabitEthernet 0/0/0
TenGigabitEthernet0/0/0 is up, line protocol is up
Hardware is BUILT-IN-2T+6X1GE, address is a0e0.af94.5000 (bia a0e0.af94.5000)
MTU 1500 bytes, BW 10000000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not supported
Full Duplex, 10000Mbps, link type is force-up, media type is unknown media type
output flow-control is on, input flow-control is on
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:02:23, output hang never
Last clearing of "show interface" counters never
Input queue: 0/375/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
971 input errors, 867 CRC, 93205524 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 packets output, 0 bytes, 0 underruns
6187 output errors, 0 collisions, 9 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
13 carrier transitions
AWS-DC-RTR#
Any Ideas on what I might be missing here?
I am trying to get the connection to work with a Cross Connect that was installed in our cage with Megaport (Megaport.com). Anyone have any experience with this?
02-09-2024 06:17 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide