02-19-2003 10:02 PM - edited 03-02-2019 05:13 AM
I have a 7513 running a RSP2 IOS 12.1(16) .A compression adaptor and a channelized E1 pri reside in a VIP2-50.
With dialers configured for ppp multilink and compression enabled the compression card does not relieve the processor. "sh compress" returns only software compression in use. (cpu utilization runs high)
In any case wouldn't the VIP take the load away from the RSP when "compress stac distributed" is enabled (it doesn't) or
Is it simply the case that multilink sessions cannot be compressed..............?????
02-20-2003 02:20 AM
Hello Martin,
I found this on CCO:
If the router contains a compression service adapter (CSA), compression is performed in the CSA hardware (hardware compression).
If the CSA is not available, compression is performed in the software installed on the VIP2 (distributed compression).
If the VIP2 is not available, compression is performed in the router's main processor (software compression).
Since you say that you can see only software compression and cpu utilization runs high, I wonder if your VIP2 is recognized at all. Have you tried to reseat it ?
Regards,
Georg
02-20-2003 01:15 PM
I have 12 active ppp multilink and some single channel sites connected to it - the VIP is definately recognized - so to is the compression card.
I cannot force disrtibuted compression - it displays "software compression" only.
Martin
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide