02-01-2006 12:09 PM - edited 03-03-2019 01:39 AM
I have connected a 9216i to the uplink port of the SUP 720 card in a 6509-E Cat Switch, and have configured that port for Vlan 2. But I cannot ping the 9216i. I have created a trunk port to a router for Vlan 1 and 2 using dot1q. Interface says connected.
Any help is appreciated.
02-01-2006 01:04 PM
Hello,
can you post the relevant configurations of the 6509, the MDS, and the routing module ? Maybe something can be spotted...
Regards,
GP
02-01-2006 01:12 PM
Do a sh interface gi x/y switchport on the Sup 720 (assuming this is IOS based). this will tell you if the port is in trunking status or not.
are you able to ping on vlan 1 ? (native)?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide