Connecting Cisco Router to System

[usmany]

Guys,

I need assistance on how I will connect my cisco router 3640 to a system not to switch/hub for troubleshooting through Ethernet port not console nor auxiliary port...

I just want to know if is possible to connect straight from the ethernet port of the router to system NIC and how will I make the cabling?

I tried straight and cross over cabling, but did even blink... I am sure there is a way in making the cabling work.

Cisco gurus should please intervain/advice on this issue

[krozier]

Hi USMANY,

It is quite possible to connect a router to P.C's, that is the best way to download IOS to the router. To connect 3640's (or any cisco router for that matter) ethernet interface to a P.C. that would require cross-over cable. After connecting the cross-over cable to the router and the P.C.you do not get a link link, you need to make sure that the ethernet port on the router is enabled and check the cabling. Let me know if you need additional pointers.

Kersean

[usmany]

thanks, i will try it now and i will brief you on any development.

[steve.busby]

Both interfaces (router & pc) should use the same IP network.

[usmany]

okay guys, i will do that as advice and get back to you too.

thanks all for the help