Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Guys, I really need your help on how to check/change the default ip address of AIR-LAP1242AG-E-K9 model.I tried to access the AIR-LAP1242AG-E-K9 via CLI but got to a stage that i can not get to the ap> prompt as attached: Pls, what could be the pr...
guys,how can i change from enable mode i.e. (router>) to (Router>#) privillage mode?i typed (router>en to change but told me there is no password set while there was before (days) back... I dont know what happened the router changed to this mode.what...
guys,i have problem with my above series of router... i was not in the office for days and when i came back i found out that i can ping my router through its ethernet0/0 where i assigned ip 192.168.1.1i used my consol cable and used hyper terminal wh...
Guys, How will i enable ip unicast RPF check on 3640 router?Also, how can i troubleshoot int ser when its line protocal is down and can't ping its ip address assign to the ser int?I suspected remote router not communicating with the ser int very well...
thanks for the tip mr. kevin, but the system don't let me do config t when its gave me (router>) and i use en (enable) it will only prompt me with (% No password set). try and see commands that are under this mode on your router (router>?).Last optio...
paddy, those this mean that i lost all my datas in the router since its gave me this (Router>)? before is named (Engine1).If its does, then why not if i just reset the Baud Reset jumper on the system board so that i can start fresh configuration on t...
okay sir, i will try that now, but my systems is winxp professional and i have another which is win2k server/advanced.... i will still try both systems (os) and brief you later on any development.thanks and i will communicate with you soonhave a nice...
thanks for the quick respond sir, but it did not show me (would you like to enter the initial config dialog?[yes/no].... but just (Router>).yes is showing % No password set... but from there, what else will i type in to get to the config t as tthere ...
