CWSI & port 14000

[wecheng]

Hi,

We run osfind command under CSCOpx\lib\visigenics\bin directory and find out that port is not 42342 as it should be and on the screen it shows port number 14000.

Just wonder what software is conflicting the port number.

I had even used the SET OSAGENT=42342 command and when I rebooted the computer, again port number 14000 is shown and error message of OSAGENT cannot connect is shown.

Thanks and rgds.

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.