07-18-2005 05:06 AM - edited 03-02-2019 11:25 PM
I am using my 3620 instead of a netgear cable router connected to cablevision.
1) How can I see when the router dhcp lease ends so I can see if it gets another address? I have seen on past posts that there were problems with this issue. I am using 12.3(13) ios.
2) How can I see how much memory has been used by nat translations? I have 64Meg of memory.
Thanks
07-18-2005 05:41 AM
Hi csross,
If I understand you correct this will resolve your issue.
1) show ip dhcp binding [ip-address]
It will show you the lease expiration like the output below
Router# show ip dhcp binding 172.16.1.11
IP add Hard add Lease expiration Type
172.16.1.11 00a0.9802.32de Feb 01 1998 12:00 AM Automatic
Here you go with the link
http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cr/hiad_r/adr_s1h.htm#wp1132199
2) Each NAT mapping uses approximately 160 bytes of memory.
I am still not sure of the command.
HTH
Ankur
07-18-2005 07:38 AM
Thanks.
With regards to
1) I am talking about the address it gets from cablevision, not the addresses it gives out. I want to see when it tries to get another address from cablevision.
2) Thanks anyway.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide