06-13-2024 08:49 AM
I am having a little situation here; for some reason I can get my switches and routers to display the dhcp relay even though it shows to be configured on the network's vlan. For example, when I entered the following command;
SW# sh ip dhcp relay information trusted-sources
DHCP Relay Trusted Port functionality not enabled.
______________________________________________
or I get the following message
SW# SW# sh ip dhcp relay information trusted-sources
List of trusted sources of relay agent information option:
_________________________________________________
So basically, no output.
I've been looking online but I'm still not able to find a good source that can provide some good insight. do you guys any troubleshooting tips or knowledge nuggets you guys can share?
06-13-2024 09:40 AM
None show you that
SW need to be dhcp relay and it l3SW to use above command.
Router since it l3 device dont run dhcp snooping.
MHM
06-15-2024 09:41 AM
Hello,
do you have 'ip dhcp relay information' configured in global configuration mode or interface configuration mode (or both) ? Can you post the running config of the switch (SW) ?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide