Disabling IPv6 on 6509

[routercpu]

I have a 6509 switch that when I do a show IPv6 interface command, the following is displayed.

LI-Null0 is up, line protocol is up

IPv6 is enabled, link-local address is

No global unicast address is configured

Joined group address(es):

MTU is 1500 bytes

ICMP error messages limited to one every 100 milliseconds

ICMP redirects are enabled

ND DAD is not supported

ND reachable time is 30000 milliseconds

LI-Null0 is up, line protocol is up

IPv6 is enabled, link-local address is

No global unicast address is configured

Joined group address(es):

MTU is 1500 bytes

ICMP error messages limited to one every 100 milliseconds

ICMP redirects are enabled

ND DAD is not supported

ND reachable time is 30000 milliseconds

I removed the addresses for security reasons. I did not enable or configure IPv6 on this switch. How do I remove or disable these IPv6 interfaces?

Thanks

[wong34539]

Give the command "no ipv6 enable" under the interface mode will disable the IPV6.Check for more information with the below link.

http://www.cisco.com/en/US/products/sw/iosswrel/ps5187/products_command_reference_chapter09186a00801d6631.html#wp1914256