Dear Experts,
We stucked with a scenario and seeking advise to overcome the same.
Existing Setup : We have two Routers (Cisco 3945) on which Point-to-Point link are connected to remote location running with static routing.
Remote Site-1 (Primary Link) --> Our Data Center Router-1
Remote Site-1 (Secondary Link) --> Our Data Center Router-2
Remote Site-2 (Primary Link) --> Our Data Center Router-1
Remote Site-2 (Secondary Link) --> Our Data Center Router-2
Proposed New connectivity : Now we have additional MPLS links for a new remote site (say Remote site-3) to our Data Center. This Remote site-3 is also have direct connectivity with Remote site-2 already. We have to Run eBGP between this Remote SIte-3 MPLS link and our Data Center.
Problem would be : when we advertise our Network on remote site-3 eBGP there would be conflict/routing loop as same route is also running with existing static routing. Please advise how to save loop and without impacting working network.
Regards
***