04-09-2018 05:13 AM - edited 03-03-2019 08:46 AM
Hi,
When trying to add this netflow config, I get an error on the last line "collect interface output":
Config:
flow record MY-RECORD
description MY Flow Record
match routing vrf input
match ipv4 tos
match ipv4 protocol
match ipv4 source address
match ipv4 destination address
match transport source-port
match transport destination-port
match interface input
match interface output
match flow direction
collect ipv4 dscp
collect counter bytes
collect counter packets
collect interface output
Error:
collect interface output
% Flow Record: Failed to field add: Failed to validate Unsetting Public:behaviour
The same happens when I try to add "collect interface input"
05-27-2018 08:46 PM
You probably have a flow monitor setup somewhere with a line
record MY-RECORD
try doing a
NO record MY-RECORD
add then do a
collect interface output
and then re-enable the flow record. at least that's what worked for me.
02-18-2019 04:49 PM
It looks like match "interface input/output" are mutually exclusive with "collect interface input/output". You can only have one in the flow record block. At least what's what I noticed.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide