find out module/port from MAC of Voip Phone

[kashyap1977]

i have 15 catalyst 4006 switches.All are connected to Catalyst 6509.

And on all my catalyst 4006, IP phones are connected.

I have certain MAC Addresses of IP phones, i dont dont know on which module/port they are connetected.

how is it possible to find out from MAC address of IP phone on which Module.port its connected.

I dont have Call Manager.

Below is the output of "SHOW CAM DYNAMIC"

sh cam dynamic

* = Static Entry. + = Permanent Entry. # = System Entry. R = Router Entry.

X = Port Security Entry $ = Dot1x Security Entry

VLAN Dest MAC/Route Des [CoS] Destination Ports or VCs / [Protocol Type]

---- ------------------ ----- -------------------------------------------

320 00-00-0c-07-ac-14 1/2 [ALL]

320 00-0b-bf-26-4b-fc 1/2 [ALL]

321 00-00-0c-07-ac-15 1/2 [ALL]

321 00-0b-bf-26-5b-fc 1/2 [ALL]

322 00-00-0c-07-ac-16 1/2 [ALL]

322 00-0b-bf-26-4b-fc 1/2 [ALL]

323 00-00-0c-07-ac-17 1/2 [ALL]

323 00-0b-bf-26-5b-fc 1/2 [ALL]

326 00-00-0c-07-ac-1a 1/2 [ALL]

326 00-0b-bf-26-5b-fd 1/2 [ALL]

327 00-00-0c-07-ac-1b 1/2 [ALL]

327 00-0b-bf-26-4b-fd 1/2 [ALL]

336 00-00-0c-07-ac-1a 1/2 [ALL]

336 00-02-a5-c1-66-d4 1/2 [ALL]

336 00-02-a5-c1-eb-2f 1/2 [ALL]

336 00-02-a5-c1-ed-da 1/2 [ALL]

336 00-08-02-d7-46-47 1/2 [ALL]

336 00-08-02-e5-2d-05 1/2 [ALL]

336 00-08-02-e5-2d-9e 1/2 [ALL]

336 00-08-02-e5-2d-b1 1/2 [ALL]

336 00-08-02-e5-2d-e9 1/2 [ALL]

336 00-08-02-e5-30-5d 1/2 [ALL]

kindly suggest.

Cheers

kashyap

[jtoye]

You can connect to the IP phones using a web browser :-

http://

Got to device information section and the mac address should be displayed. For more info see :-

http://www.cisco.com/en/US/products/hw/phones/ps379/products_administration_guide_chapter09186a008020d879.html#wp1082880

[kashyap1977]

hi

i have tried connecting the phone through browser, but its not happening.

is there anyother way for this problem.

[thisisshanky]

All phones run CDP. Your switch should definitely be running CDP. Give a show cdp neighbor or show cdp neighbor detail to get the mac-address and IP address of IP phone. This command will also show the port on the switch where each individual phone is connected. Hope that helps!