cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
378
Views
0
Helpful
1
Replies

Help

jayaraj.nair
Level 1
Level 1

Hello,

I am having a uBR 924 with nat enabled having private ip on ethernet interface.It is configured for loop back address.After working for four hours,uBR releases it's ip address.Then i have to restart the uBR to get internet.IOS is 12.2(3).Please help me

Jay

1 Reply 1

ciscomoderator
Community Manager
Community Manager

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

Review Cisco Networking for a $25 gift card