Loading backup config and IOS from sup-slot0: on MSFC.

[frank]

We have 6509 running hybird mode, 6.1(2) CatOS and 12.1(4)E1 IOS.

How can I setup MSFC to load both IOS and configuration from sup-slot0: in case either the config on NVRAM or IOS on bootflash: corrupted?

Would "boot system flash sup-slot0:<file_name>" override the current setting or it will append to the end as on CatOS?

Would "boot config sup-slot0:<file_name>" override the current setting or it will append to the end as on CatOS?

[vmoopeung · Accepted solution]

Detailed explanation of same is in this page:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_6_3/confg_gd/redund.htm

Regrding second question, as far as my knowledge goes, both commands will append the settings.