cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
677
Views
0
Helpful
3
Replies

Local Director and NFS

rsarra
Level 1
Level 1

I have a LD 416 with Sw version 4.1.1 and I found that the NFS protocol doesn't work when installing the LocalDirector between two servers.

I found the bug number CSCdt05312, but I can't find the solution for this problem wich is similar to mine (I hope).

Thanks in advance,

Roberto

3 Replies 3

b59048
Level 1
Level 1

In theory, if you are using the LDIR as a bridging

device, it should work, e.g.

NFS Client - Interface 0 LDIR Interface 1 - NFS SRV

and you have 'no secure 0' and 'no secure 1'

If this is your setup and it still does not work,

my only suggestion is either trying LDIR 4.2.2 or

open a TAC case.

If this is not your setup, are you then using the

LDIR to load balance the NFS Clients to multiple

NFS servers?

/Johnny

I'm using the LDir as a bridging and all other services are working fine.

Johny is correct! LDIR should bridge anything that is not destined to the vip unless the secure is enabled. If secure is enabled the only traffic that will pass through the LDIR is the traffic destined for it. I would recommend you open up a case with the TAC.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco