06-20-2003 12:14 AM - edited 03-02-2019 08:17 AM
Is it possible to do NAT inside-to-ouside for the IP address of a loopback interface of a router ?
Even more, can I use route-maps with this NAT ?
NOTE: This loopback interface is used for DLSw connections.
Thanks in advance
06-26-2003 07:43 AM
1) You can use NAT on the loopback interface of the router .
2) The following link gives you how to configure Route Maps with Static NAT. http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122t/122t4/ftnatrt.htm#wp1021949
06-26-2003 10:27 PM
Thanks, I've already tested in a lab environment and it works.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide