02-09-2004 07:36 AM - edited 03-02-2019 01:28 PM
12.0(5.30WC1
3548XL switch
When you do a show run, it doesn't display any output. When you do a sh config, it shows. You make a change to config, and do a wr mem, the change can be seen in sho config. But show run gives no output.
I have seen some bugs which says in low memory condition this problem could occur. This switch however doesn't have a high mem utilization.
02-13-2004 08:48 AM
Irrespective of mem utilization, you need to have atleast 8MB of memory. Apart from bugs on less memory, I guess there should be no other problem.
02-16-2004 12:37 AM
Hi,
is there any difference using sh run and write term commands?
From console or Telnet session?
Have you reloaded the switch?
Regards,
Milan
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide