cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
297
Views
0
Helpful
1
Replies

Non Documented Error Message on Catalyst 2948G

neil.mcguinness
Level 1
Level 1

We have an issue with a 2948G which is running CatOS6.3(10) but connected via short haul fibre gbic to a 4003 running version CatOS 5.1(1a). The 2948G has been installed a couple of weeks and loses connection to the 4003 every couple of days, since it was installed. The 2948G switch has been rebooted whenever the problem occurs. The 4003 switch has been installed since last year with no problems, Only the 2948G has been introduced.

The Fibre connection between the two switches has been replaced by a UTP connection instead. Currently we are finding out whether this has made any difference and stoppped the initial connection loss.

What I have noticed on the 4003 switch is the following error over and over again which doesn't seem to be documented in the TAC. An example is below and was wondering if anyone has any ideas as to what this message means.

2004 Aug 17 14:23:10 EET +03:00 %SYS-4-P2_WARN: 1/Internal Event: ScxSwitchMan -

Protocol Table Packet on address 00:10:7b:ab:99:6f arrived on unexpected port

2004 Aug 17 14:23:44 EET +03:00 %SYS-4-P2_WARN: 1/Internal Event: ScxSwitchMan -

Protocol Table Packet on address 00:10:7b:ab:99:6f arrived on unexpected port

Many Thanks,

Neil McGuinness

1 Reply 1

milan.kulik
Level 10
Level 10

Hi,

I've found a notice about this message in

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/relnotes/78_6301.pdf

HTH,

Milan