- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-22-2004 04:41 AM - edited 03-02-2019 06:40 PM
Why are Some OSPF Routes (Stub Area) in the Routing Table but not in the OSPF Database ?
Thanks.
Solved! Go to Solution.
- Labels:
-
Other Networking
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-22-2004 04:51 AM
This would proably be a bug. "clear ip route
Hope this helps,
Harold Ritter, CCIE #4168 (EI, SP)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-22-2004 04:51 AM
This would proably be a bug. "clear ip route
Hope this helps,
Harold Ritter, CCIE #4168 (EI, SP)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-22-2004 05:29 AM
With " clear ip route
The prblm ist that the route in the OSPF Table is the right entry (intra-area) and sometimes the bad route (E1) is taken and this entry is in the OSPF database . After clear route the router takes the intra-area entry again but it is not in the OSPF database.
Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-22-2004 09:20 AM
Could you post the output of show ip route, the output of show ip ospf database and indicate which route(s) you are talking about that are in the routing table but not in the data base?
HTH
Rick
Rick
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-07-2012 08:38 AM
The prblm ist that the route in the OSPF Table is the right entry (intra-area) and sometimes the bad route (E1) is taken and this entry is in the OSPF database
I beleive this problem is related to the "Stubby" configuration on the router. You've said that "E1" route is taken which is a Type 5 LSA and Type 5 LSAs are not allowed in a Stubby areas.
As Rick said, can you upload the mentioned outputs along with your running config?
Regards,
AM
