09-29-2004 06:12 AM - edited 03-02-2019 06:51 PM
Good Day,
I have two 2500 routers connected via crossover serial and have been unable to successfully configure RIP or OSPF.
In both cases, one router receives the routing tables correctly, but the other does not.
One difference I have noted is that show ip protocol returns different results.
The router that is successfully receiving the updates returns:
outgoing (and incoming) update filter list is not set
The router that is not receiving updates returns:
outgoing (and incoming) update filter list is
It just "is" nothing more, and this seems typical.
Interestingly, EIGRP worked OK.
Any insights appreciated.
10-05-2004 01:02 PM
At one side if you configure RIP v1 only and other side default (will accept and understand both v1 and v2), then you see the same problem. I feel that you are experiencing the same problem.
10-05-2004 05:43 PM
Could you post the configs please?
Kevin Dorrell
Luxembourg
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide