Policy Routing

[john.carter]

Is policy routing applied on the incoming traffic of an interface only?

[svermill]

Yes, more or less. With route maps, you 'match' incoming conditions and 'set' outgoing conditions. For instance, match incoming IP address and set outbound interface to some value.

By the way, I used to stop for gas in Keflavik occationally. I would liked to have seen it in the summer just once.

[john.carter]

So it is applies to in and out traffic with just the route map command...thanks

I hope I am not here in Kef to see another summer myself 2 is plenty

[svermill]

I hope my anwer wasn't misleading. The official Cisco answer is that policy routing applies to incoming *packets* only but in reality, of course, there is an outbound aspect - the 'set' portion of the route map.

Regards,

Scott

[tomek0001]

You can also apply policy routing for traffic locally generated from the device with something like ...

conf t

ip local policy route-map PBR

(hope that helps)

TK