Hi all,
may some of you tell me the real meaning of the sub-command "set interface <intf>" under the route-map section?
I thought it was like the <intf> parameter whe you set a route out of an interface.
I tried it with a PIX that should have to act as proxy-arp device but nothing happened.
Everything worked fine using "set ip next-hop ..."
The topology appears a little bit complicated if explained how I built it in practice.
Just a PIX525, a switch and a router 877 that manages VLANS.
I reproduced the environment that doesn't see 2 ethernet interfaces on the router where the policy is applied but 1 serial and 1 ethernet. By now there are 2 devices, one per link, and the def route is based on proxy-arp both for the serial and the ethernet.
Hope the scenario was clearly depicted.
TIA
Alex
