"Class"-based config for interfaces?

[cisco]

Is there a way to make a "class" for an interface that contains the config for an interface, and then specify that class in the interface config? This is for an ATM interface.

I see that you can make a vc-class for individual PVCs on an ATM interface, but I just want to make a general config for a large number of ATM interfaces with identical configurations, not just the pvc part of the interface.

[bsivasub]

vc http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fwan_c/wcfatm.htm#35055

[cisco]

Thanks for the reply. But I already knew you could make a vc class for an ATM interface, but there are only pvc type parameters you can specify for that class. You can't specify that the interface is in a bridge group, or give it an "ip helper-address", etc. I just wanted to know if there is a "general interface class" I can use to put config commands that apply to interfaces in general. Not just pvc parameters.