anyone knows a equivalent show command to get the "FIB TCAM Usage" on An ASR 1006 ?
the "show platform hardware capacity forwarding" does not work on ASR1006
Example on 6500:
Router# show platform hardware capacity forwarding
L2 Forwarding Resources
MAC Table usage: Module Collisions Total Used %Used
1 0 65536 10 1%
VPN CAM usage: Total Used %Used
512 1 1%
L3 Forwarding Resources
FIB TCAM usage: Total Used %Used
72 bits (IPv4, MPLS, EoM) 917504 730624 80%
144 bits (IP mcast, IPv6) 65536 7 1%
detail: Protocol Used %Used
IPv4 365337 40%
MPLS 365286 40%
EoM 1 1%
IPv6 1 1%
IPv4 mcast 3 1%
IPv6 mcast 3 1%
only found:
ASR#show platform hardware qfp active tcam resource-manager usage
Total TCAM Cell Usage Information
----------------------------------
Name : TCAM #0 on CPP #0
Total number of regions : 3
Total tcam used cell entries : 284
Total tcam free cell entries : 524004
Threshold status : below critical limit
but how do I understand the "Total tcam free cell entries" and how can I find some infos about the "FIB TCAM usage"
thx
