Reset DSP on 3600

[admin_2]

How to reset DSP on the 2600 and 3600 without reset the controller or reset the routers.

[#2]

Most cases, the best practice is to reset the box or

controller for dsp reset but you can use this

few methods too.

1. go unto the voice-port and do a shutdown, no shutdown.

this will reset the dsp used by that particular voice port

2.go to the voice port and do a busyout forced and no busyout forced.

This too will reset the dsp per voice-port

3.go under the controller for cas trunks and do

ds0 busyout 1-24 & no ds0 busyout 1-24, this will rest the dsp based on the timeslot

specified.

[garza.javi]

Hi,

you can also issue the  test dsp device [SLOT ID] [DSP ID, all] reset    command under priviledge exec mode. Afeter that, the RST count on the sh voice dsp command should increase by one.

    Besr regards.