We have recently upgraded all our WAN router to Cisco 3945, they all have the same FLOW config as below
but when I do a sh flow export statistics
on some routers I get:
Flow Exporter Export-FNF-Plixer:
Packet send statistics (last cleared 1d08h ago):
Successfully sent: 0 (0 bytes)
Enqueued to process level: 2534452 (3484784053 bytes)
on others I get:
Flow Exporter Export-FNF-Plixer:
Packet send statistics (last cleared 14w2d ago):
Successfully sent: 16545298 (22596920223 bytes)
Enqueued to process level: 165 (223914 bytes)
as I said all the configurations are basically the same
Does anybody know what causes this difference?
Flow config:
flow record Record-FNF
description Flexible NetFlow with NBAR Flow Record
match ipv4 tos
match ipv4 protocol
match ipv4 source address
match ipv4 destination address
match transport source-port
match transport destination-port
match interface input
match flow direction
match application name
collect routing source as
collect routing destination as
collect routing next-hop address ipv4
collect ipv4 dscp
collect ipv4 id
collect ipv4 source prefix
collect ipv4 source mask
collect ipv4 destination mask
collect transport tcp flags
collect interface output
collect counter bytes
collect counter packets
collect timestamp sys-uptime first
collect timestamp sys-uptime last
!
!
flow exporter Export-FNF-Plixer
description FNF v9
destination 172.16.6.219
source Loopback0
output-features
transport udp 2055
option interface-table
option application-table
!
!
flow monitor Monitor-FNF
description FNF Traffic Analysis
exporter Export-FNF-Plixer
cache timeout active 60
record Record-FNF
!
!